Hardened steel wheel in metal die-cast holder with red stove enamel finish. For flat glass 3-6mm. For handyman use.
|
 |
Hardened steel wheel in a replacement clip for easier changing of wheels. Fitted to a die-cast handle with yellow stove enamel finish. For flat glass 3-6mm.
|
|
Consisting of six high quality carbon steel wheels precision ground and inspected. Suitable for general purpose cutting. The body being moulded in nylon glassfibre loaded for high impact strength. For flat glass 3-6mm.
|
|
Blue nylon handle , single wheel glasscutter for DIY use on flat glass from 3 mm to 6 mm.
|
|
A single wheel glass cutter fitted to a metal die-cast handle. The wheel is of tungsten carbide. For flat glass 3-6mm, or makes a excellent tile cutter. Wheel Angle : 125°.
|
|
A tungsten carbide wheel unit is fitted to a green enamelled die-cast handle. The wheel and carrier are replaced as a unit. For flat glass 3-6mm. Higher quality wheel gives greater precision than model 700. Wheel Angle : 125°
|
|
A traditionally shaped professional glass cutter which has a wooden handle, swivelling block and tungsten carbide wheel. For use on flat glass 1.5-5mm, picture glass, hard glass (not toughened), cathedral glass, and stained glass.
|
|
A tungsten carbide cutter with quick change wheel and carrier unit. Handle is made of cast iron for greater strength general purpose cutter but suitable for hand cutting use. Can be used on flat glass (3-6mm), plate glass and laminate glass (cut both sides). Wheel Angle : 125°
|
|
Designed for all types of cutting - curves as well as straight lines. Special grade tungsten carbide wheel and axle. Block can swivel or be locked in one position. Carefully designed wooden handle. For flat glass 3-6mm, textured glass, laminated glass (cut both sides) and architectural glass.
|
|
A tungsten carbide wheel glass cutter fitted to a hardened steel block for increased wear resistance. Wooden handle for comfort in use. Very high specification together with a hand ground larger wheel makes this the perfect cutter for continuous straight line cutting.
|
|
A tungsten carbide wheel cutter .The spring loaded block allows a small amount of lubricant onto the cutting line making for smooth, easy cutting. The oil is stored in the hollow plastic handle. A good general purpose cutter for all types of glass.
|
|
Over Centre Lever operating suction pad for firm location on glass, with clear dual inch/metric scale reading for diameter of circle. Easy thumb screw adjustment fitted with carbide replacement wheel for long life. Max. 1200mm. Diameter.
|
|
Over Centre Lever operating suction pad for firm location on glass, with clear dual inch/metric scale reading for diameter of circle. Easy thumb screw adjustment fitted with carbide replacement wheel for long life. Max. 600 mm Diameter.
|
|
