Stop Cock Keys

Crutch Pattern Stopcock key with 1/2in and 3/4in valve insert. Turning handle has one point end for lifting. Length 90cm / 35.1/2in.

For reaching and turning off/on stopcocks set below ground level. Zinc plated for corrosion resistance. 1/2in square x 34in long.

For reaching and turning off/on stopcocks set below ground level. Zinc plated for corrosion resistance. 1/2in square x 42in long.

For reaching and turning off/on stopcocks set below ground level. Zinc plated for corrosion resistance. Crutch Head x 34in long.

For reaching and turning off/on stopcocks set below ground level. Zinc plated for corrosion resistance. Crutch Head x 42in long.

For use on difficult to reach crutch head stopcock valves located under kitchen units and other awkward positions offering extra leverage to stiff valves. Length 26 cm - 10 1/4 in

This simple, adaptable yet highly effective tool can operate both crutch head and wheel head valves. It uses conventional U-channel to operate crutch head valves and a pair projections to operate wheel head valves. It allows the end user to easily reach those hard to access valves , for example behind kitchen sink units back panels, or in airing cup-boards, and opens up infrequently used valves that are normally impossible to turn by hand. For use on 15mm, 22 mm and 28 mm valves. Length: 8 1/2in

Designed to accommodate 1/2in and 3/4in crutch head pattern stop valves, and 1/2insq, 5/8insq, and 1insq, stop valves all in one tool. The handle is removable from one end to the other depending which end is required for use. Manufactured from steel and plated for corrosion resistance. Length. 34in

Designed to accommodate 1/2in and 3/4in crutch head pattern stop valves, and 1/2insq, 5/8insq, and 1insq, stop valves all in one tool. The handle is removable from one end to the other depending which end is required for use. Manufactured from steel and plated for corrosion resistance. Length. 42in.